FSB1 - Fuse Holder Conductor Boot
Description
Specifications
0.05lb
0.87mm
0.87mm
3.43mm
Street Lighting, Parking Lot Lighting, Traffic Signaling, Sports Lighting, Boats and Marinas and Humid/Corrosive Environments Applications
Mersen
USA
MX
BOOT COND SGL FEB FEC FEX
Breakaway version quickly disconnects line side during pole knockdown in compliance with state and federal highway commission standards
3 O-rings per pole for water tight applications
Colored O-rings for quick detection
Single and dual poles
Wide assortment of terminal variations
High heat, impact resistant insulator
Captive nut or screw for quick installations
Polarized dual pole provides simultaneous disconnection
Permanently installed neutral versions quickly identified by white nuts
Tulip fuse clip for improved contact and low losses
Environmentally friendly-no lead solder used
Highly visible catalog number even with insulation boots installed
Wire gage size identified on insulation boots for quick, accurate trimming
Mersen
0.8700
IN
3.4300
IN
1
0.0500
LB
0.8700
IN
Ferraz Shawmut
CLIPS, REDUCERS, REJECTORS, ETC.
Suitable For Use With
FEB, FEC, FEX, FEY Series 600 V In-Line Fuseholder
